Description
This loom is specifically designed to power low-voltage LED grill lights on the Mitsubishi L200 (2015–present), as shown in our product examples. It provides a clean plug-and-play solution for powering small LED accessories when your headlights are turned on. However, if you plan to install a light bar or any higher-wattage lighting, you must use a relay wiring loom to safely handle the increased current and protect your vehicle’s electrical system.
I wasn’t satisfied with any of the existing LED grill lighting solutions for the L200, mainly for two reasons:
1. I dislike tapping into the vehicle’s wiring, as I’ve seen the long-term damage caused by moisture creeping into looms after cheap installs.
2. Direct fuse box wiring was awkward — especially when it came to removing mods for MOTs or dealership work under warranty.
So, I designed a better solution. You simply unplug an existing headlight adjuster connector, plug in our loom, and wire in your LEDs. This gives you a safe 12V feed that is only live when your headlights are on, without interfering with the factory wiring. You can use solder with heat shrink or waterproof butt connectors, either way there’s no risk to the CAN system or BCM, and the grille lights will only come on when your headlights are switched on.
Benefits:
1. No cutting into your vehicle’s main wiring loom – your factory wiring stays untouched, keeping things safer and more reliable.
2. Plug-and-play installation — no need for mechanical or electrical expertise. Just join your LED’s red to red and black to black. (We recommend fitting an inline fuse.)
3. Keep your warranty safe — if the vehicle goes in for warranty work, just unplug the loom and reconnect the original plug. No trace, no issues.
4. Quick removal for MOTs — if your L200 risks failing due to extra DRLs, you can remove them in seconds by unplugging the loom.
This method keeps your LED lights on when your headlights and main beam are on only.




Reviews
There are no reviews yet.