Remote Controlled Relay Kit – Work Lights Etc.

£19.99

Remote Controlled Relay Kit – Work Lights Etc.. Automotive lighting upgrade with compatibility and fitting information shown on the product page.

Description

AutoVolt® Remote Controlled Relay Kit

Wireless Control for Rear Work Lights and Auxiliary Lighting

This remote controlled relay kit provides simple wireless on and off control for rear work lights and auxiliary lighting on vans, pickups and 4x4s.

The relay module mounts under the bonnet to the battery or any 12-volt supply, allowing you to run your desired length of wire to your lights and switch them using the supplied remote handset, eliminating the need to install a dashboard switch.

Recommended maximum load: 120 W total

Recommended load wire: 1.5 mm² (approx 16 AWG) up to 5 metres

Important: This relay module is not waterproof and must be installed in a dry location under the bonnet or inside a suitable enclosure.

Key features

  • Wireless remote control for rear work lights and auxiliary lighting
  • No dashboard switch or cabin wiring required
  • Relay module mounts under the bonnet near the battery
  • Multiple programmable operating modes
  • Supplied with fused battery positive lead and battery earth lead
  • Spare terminals included for customer-supplied load wiring

What is included

  • Wireless relay control module
  • Remote control handset
  • Fused battery positive supply lead
  • Battery earth lead
  • Spare crimp terminals for customer-supplied wiring

Suitable for

  • Rear work lights on vans, pickups and 4x4s
  • Scene lighting for commercial and utility vehicles
  • Auxiliary LED lights requiring wireless control

Specifications and recommendations

System voltage 12 V DC
Recommended continuous load 120 W total
Maximum short duration load 180 W total
Recommended load cable 1.5 mm² (approx 16 AWG)
Recommended cable run Up to 5 metres (rear of vehicle to relay)

Operating modes

  • On and off (latching): press once to turn the lights on, press again to turn them off.
  • Momentary: lights remain on only while the remote button is pressed.
  • Timed on: lights switch on for a selectable delay of up to 20 seconds, then turn off automatically.

Mode selection is completed directly on the control unit using the onboard programming procedure. No software or additional tools required.

Professional installation is recommended if you are unfamiliar with vehicle wiring. Exceeding the recommended load limits or incorrect wiring may reduce service life or cause faults.

Additional information

Weight 200 g
Dimensions 20 × 15 × 10 cm

Reviews

There are no reviews yet.

Be the first to review “Remote Controlled Relay Kit – Work Lights Etc.”

Your email address will not be published. Required fields are marked *

×