Gloss or Matte Black, Big Letter Design

Raptor style grille for the T7 and T8 Ranger.

Gloss black or matte black with large block lettering across the front. Pick your finish, then choose no lights or three super bright LEDs in amber or white, all from the menu above.

T7 and T8, 2016 to 2022.

Made in two versions, one for the pre-facelift T7 and one for the 2019 facelift T8, so pick your model from the menu above. A direct replacement for the Wildtrak grille, using the factory fastening points, so nothing gets cut and nothing gets drilled. It will not go on an XL, XLT or Limited, any year. Check your trim before ordering.

Wiring included, if you want it.

Pick your model, finish, lights and wiring in one go from the menu above and the whole job turns up in one box. Wiring is only needed if you choose amber or white lights. What each option gives you is below.

Which Option Do I Need?

A fuse tap works, but it means finding a suitable circuit, getting into the fuse box behind the trim, and hoping you have picked one that is genuinely ignition switched and not sharing with something that matters. Plenty of people do it. It is just fiddly and easy to get wrong.

Our piggyback loom skips all that. Unplug the headlight adjuster connector, plug the loom in between, connect your grille LED wiring to it. No cutting, no scotch locks, no fuse box. Pull the loom back out and the truck is standard again, which matters if it ever goes back to the dealer.

• No wiring – grille on its own. Sort the 12V feed yourself.
• Plug and play loom – grille plus our standard piggyback loom. LEDs run at full brightness with the ignition.
• Plug and play loom + dimmer – grille plus the loom and a PWM dimmer. The LEDs drop to your chosen level when the headlamps come on, then go back to full when the headlamps go off.

Already own our standard loom? Take the no wiring option here and buy the PWM loyalty upgrade on its own, so you are not paying twice for the piggyback.

The loom covers Ford Ranger 2011-2022, all trims. It does not fit the T9 from 2023 on. The PWM dimmer is rated for 2 amps total LED load, so check your draw before adding anything else to the same output.