Description
Ford Ranger Micro2 Fuse Tap | Add-A-Circuit
A simple, fully reversible way to take a fused 12V feed from the interior fuse box for low-current accessories. No cutting, no splicing, no drilling.
We wouldn’t normally recommend fuse taps, but inside the cab it’s a different story. The interior fuse box is away from water and weather, so for small interior accessories a fuse tap is the simplest, neatest option.
Fitment
- Ford Ranger 2012-2022 (T6, T7 and T8) interior fuse box
- Any other vehicle that uses 2-pin Micro2 fuses
Check your fuse before ordering. A Micro2 fuse is 9.1 mm wide with two narrow blades close together. A standard mini blade fuse is about 10.9 mm wide and will not fit this tap. See the dimension drawing and caliper photo in the gallery.
Why a fuse tap inside the cab
- No cutting or splicing. The factory loom stays exactly as it left the factory.
- Fully reversible. Pull the tap out, refit the original fuse, and the vehicle is back to standard.
- Each circuit keeps its own fuse. The original circuit stays protected by its original fuse, and your accessory gets its own fuse sized to suit. Far better than a wire wrapped round a fuse leg or a splice connector on the nearest live.
- No new cable through the bulkhead. Running a fresh feed from the battery for a small accessory is more work, and more risk, than the job needs.
- Your choice of feed. Use an ignition-switched fuse so the accessory turns off with the vehicle, or a permanent live if it needs to stay on.
Good for
- Dash cams
- USB chargers and phone holders
- Interior LED lighting
- Switch panel and relay trigger feeds
Not for
Spotlights, light bars, compressors, inverters or any other high-current load. These need a dedicated fused battery feed and a relay. See our relay looms below.
Specification
- Fuse type: Micro2, 2-pin
- Micro2 fuse size: 9.1 mm wide x 15.3 mm tall x 3.8 mm thick
- Vehicle: Ford Ranger 2012-2022 interior fuse box, plus any vehicle using Micro2 fuses
- Use: 12V low-current interior accessories
- Fuses included: 4 x Micro2 fuses, 3A, 5A, 10A and 15A
- Connection: bullet connector supplied for your accessory wire
What’s in the box
- 1 x Micro2 add-a-circuit fuse tap
- 1 x bullet connector, to join your accessory’s positive wire to the end of the fuse tap lead
- 1 x 3A Micro2 fuse
- 1 x 5A Micro2 fuse
- 1 x 10A Micro2 fuse
- 1 x 15A Micro2 fuse
Pick the fuse that suits your accessory, and never fit a bigger fuse than the accessory or its cable is rated for.
Fitting it properly
- Ignition off. Pick a fuse on a non-critical interior circuit, switched or permanent to suit your accessory.
- Remove that fuse. Use a test light or multimeter to find the live side of the empty slot, then push the tap in so the new circuit takes its feed from the live side.
- Refit the original fuse in the tap’s original-circuit slot, and fit a fuse rated for your accessory in the second slot.
- Crimp the supplied bullet connector onto your accessory’s positive wire and plug it into the end of the fuse tap lead. Then earth the accessory to a good chassis point, and test before refitting any trim.
Powering spotlights or a light bar?
Our relay looms take power straight from the battery through their own fuse and relay. View the AutoVolt high beam relay power loom
For 12V negative earth vehicles. Fitting by a competent person. AutoVolt Solutions Ltd cannot accept responsibility for incorrect installation or use.





Reviews
There are no reviews yet.