Description
AutoVolt® Remote Controlled Relay Kit
Wireless Control for Rear Work Lights and Auxiliary Lighting
This remote controlled relay kit provides simple wireless on and off control for rear work lights and auxiliary lighting on vans, pickups and 4x4s.
The relay module mounts under the bonnet to the battery or any 12-volt supply, allowing you to run your desired length of wire to your lights and switch them using the supplied remote handset, eliminating the need to install a dashboard switch.
Recommended maximum load: 120 W total
Recommended load wire: 1.5 mm² (approx 16 AWG) up to 5 metres
Important: This relay module is not waterproof and must be installed in a dry location under the bonnet or inside a suitable enclosure.
Key features
- Wireless remote control for rear work lights and auxiliary lighting
- No dashboard switch or cabin wiring required
- Relay module mounts under the bonnet near the battery
- Multiple programmable operating modes
- Supplied with fused battery positive lead and battery earth lead
- Spare terminals included for customer-supplied load wiring
What is included
- Wireless relay control module
- Remote control handset
- Fused battery positive supply lead
- Battery earth lead
- Spare crimp terminals for customer-supplied wiring
Suitable for
- Rear work lights on vans, pickups and 4x4s
- Scene lighting for commercial and utility vehicles
- Auxiliary LED lights requiring wireless control
Specifications and recommendations
| System voltage | 12 V DC |
| Recommended continuous load | 120 W total |
| Maximum short duration load | 180 W total |
| Recommended load cable | 1.5 mm² (approx 16 AWG) |
| Recommended cable run | Up to 5 metres (rear of vehicle to relay) |
Operating modes
- On and off (latching): press once to turn the lights on, press again to turn them off.
- Momentary: lights remain on only while the remote button is pressed.
- Timed on: lights switch on for a selectable delay of up to 20 seconds, then turn off automatically.
Mode selection is completed directly on the control unit using the onboard programming procedure. No software or additional tools required.
Professional installation is recommended if you are unfamiliar with vehicle wiring. Exceeding the recommended load limits or incorrect wiring may reduce service life or cause faults.



Reviews
There are no reviews yet.